C6owners :: Forums :: C6 Support :: The Garage |
<< Previous thread | Next thread >>
|
Worried |
Please Register to enjoy additional Member Benefits |
Author | Post | ||
DZR |
|
||
Joined: May 19 2015
Member No: #2168
Location: Halmstad |
As posted earlier, I´ve just bought a Diagbox software from Easydiagnostics, and I´m now slowly learning to "handle" it. At my first diagnos I did get a red line saying "Communication error" with the right headlamp hight adjuster. Today I discovered the little folders to the left of certain ECU:s, indicating errors. I found the following fault codes: U1116 U1118 U1205 and U2005. Not sure what I´m looking for, I decided to take a look at the fuses. Lifted the cover under the hood, and found a couple of cables that was cut and isolated. (see pictures) I am now very worried, as I can´t find where this cables are supposed to be connected. Could this have something to do with the fault codes I´m getting? |
||
|
|||
e3steve |
|
||
Joined: Jan 21 2013
Member No: #1163
Location: Warsash, Hants & Palma de Mallorca, Spain |
Cables that are not required on your model. | ||
|
|
||
DZR |
|
||
Joined: May 19 2015
Member No: #2168
Location: Halmstad |
Thank you e3steve! I was a bit worried over them, since it looked like the insulation was homemaid.. | ||
|
|
||
e3steve |
|
||
Joined: Jan 21 2013
Member No: #1163
Location: Warsash, Hants & Palma de Mallorca, Spain |
DZR wrote ... My 2.7 has several like that in the electronics' box under the bonnet!Thank you e3steve! I was a bit worried over them, since it looked like the insulation was homemaid.. |
||
|
|
||
DZR |
|
||
Joined: May 19 2015
Member No: #2168
Location: Halmstad |
Thanks! Now I must find out what the error codes means, U1116 U1118 U1205 U2005 and a connection error to the right headlamp hight corrector. Everything seems to work on the car, incl the headlamp, which is moving when I start the car. However, the car feels firm in the front and as it has poor damping in the rear. | ||
|
|
||
C6Dave |
|
||
Member No: #1
Location: Northumberland |
Error Code Info: - Click Here - U1116 - No tech doc but: Absence of communication on the CAN with the suspension ECU U2005 - No tech doc but: RCD fault: Vehicle speed information fault (absent or not valid) |
||
|
|
||
DZR |
|
||
Joined: May 19 2015
Member No: #2168
Location: Halmstad |
Thanks, Dave! So no communication, neither with suspension ECU or BSI ECU via CAN (U1116 U1118).. I have non of the problems associated with U1118, no lack of power, no starting problems or jerking/stalling. I have no clue on where to begin. About the steering wheel angle, I think I read somwhere that it could be a bug in Diagbox/Lexia? If not, do you know if it´s possible to calibrate that sensor somehow? |
||
|
|
||
Tjensen |
|
||
Joined: Jul 17 2012
Member No: #954
Location: Bergen |
My garage people do not worry about the steering wheel angle signal fault, they just reset it, saying that it is a buildt in error that is not serious | ||
|
|
||
User Colour Key: Head Administrator, Administrator, C6 owner, Technical Expert, C6 Premier Discount Club |