Login   

cruiserphil has thanked the following posts:

Location of the EGR butterfly unit? C6 2.2
Yes, that's the one. Check the plug and the wiring on damage, bent pins etc., if the pins don't look shining copper colour, use a contact spray to clean them.

Good luck!
Robert
Thanked 1 time
Posted by arconell3 on 16 January 2021

2.7 HDI Radiator repair
In addition:

One can order the original radiator from Citroen #1330P7 for about 400€ (if available) or

an "Engine Radiator Exchange" #133364 for 240€ (if available)

Maybe that's the one from Valeo...

Val...
Thanked 1 time
Posted by Fraunie on 15 January 2021

2.7 HDI engine cuts out, MAF A and B errors
I assume those are the only fault codes? Have you tried putting in a new air filter? And while you are at it, also clean the air filter housing and the tubing to the air filter.

Regards, Robert
Thanked 1 time
Posted by arconell3 on 15 January 2021

2.7 HDI Radiator repair
Fraunie wrote ...

Do you think the radiator sold by Citroen is any different? The price is for sure...


Citroen will not be the manufacturer, I'm wildly guessing it would be a valeo or nissen part
Thanked 1 time
Posted by C6Marcy on 14 January 2021

wiper motor
I'm unsure if they are the same but I'm breaking a C6 so will try and get a part number over the weekend for you
Thanked 1 time
Posted by C6Marcy on 14 January 2021

2.2 HDi, limp mode after a EGR valve change, resetting with Lexia or any other thoughts ?
Good evening
I'm sure the cables are all connected. The thing is that the error code "shortcut between cables" where there before I changed the EGR. But i absolutely have to go over the connections aga...
Thanked 1 time
Posted by CitroSuède on 14 January 2021

2.2 HDi, limp mode after a EGR valve change, resetting with Lexia or any other thoughts ?
Frankly, that looks like the new EGR has not been electrically connected at all. Either the plug came off or you forgot to plug it in?

The EGR is a simple device, with an electric motor driving the val...
Thanked 1 time
Posted by arconell3 on 14 January 2021

2.2 HDi, limp mode after a EGR valve change, resetting with Lexia or any other thoughts ?
So after some lexia-session I have ; (my pretty awkward translations from Swedish)
“Permanent fault signal from potentiometer for egr-butterfly location blocked during afterheating “ ( was able to dele...
Thanked 1 time
Posted by CitroSuède on 13 January 2021

2.2 HDi, limp mode after a EGR valve change, resetting with Lexia or any other thoughts ?
Thank a lot!
I’ll have a new diagnosis done this evening and I’ll see if I can translate my Swedish lexia codes to get it more comprehensible.
Thanked 1 time
Posted by CitroSuède on 13 January 2021

2.2 HDi, limp mode after a EGR valve change, resetting with Lexia or any other thoughts ?
Hi Citrosuède,
There are a few things you may want to check. For starters, a new EGR should be registered in Lexia, so that the BSI knows there is a new EGR, which will subsequently be initialized by t...
Thanked 1 time
Posted by arconell3 on 13 January 2021

Go to page       >>