Login   

FraserG has thanked the following posts:

Greetings from Preston (part 3)
A couple of pictures








Thanked 1 time
Posted by Trainman on 09 October 2019

HUD wandering up and down
You should just adjust your seat height.

Just kidding, it sounds like the unit's faulty. I've seen many C6-es being parted out and those HUDs don't seem to be selling well, so you should find a used pa...
Thanked 1 time
Posted by Paulius on 08 October 2019

Citroen C6 heated seats
Hello Paulius,

My understanding is that there is a pressure sensor in the seat cushion that detects if a person is sitting in the seat? Only then does the heater operate regardless of the switch being ...
Thanked 1 time
Posted by cruiserphil on 07 October 2019

The DPF System and how it works
There have been a few queries about how the system works in a C6 Diesel so I have copied this from an original Citroen document which basically explains how the ECU decides when the DPF requires a 're...
Thanked 1 time
Posted by C6Dave on 06 October 2019

C6owners.org is 10 years old
Congratulation to the forum & all those who’ve contributed.
I bought my first C6 eight years ago & think I joined a little while before that.
I’ve been driving C6 since the first UK cars were ...
Thanked 1 time
Posted by Hattershaun on 02 October 2019

C6owners.org is 10 years old
C6owners.org was set up on the 1st of October 2009, yes that's 10 years ago now. Where has all the time gone....

A big thank you from the Admin Team to all those members who have supported the site and...
Thanked 1 time
Posted by C6Dave on 02 October 2019

Greetings from Preston (part 3)
Trainman wrote ...

Well, I’ve gone and done it again, I’ve bought a 2008 2.7 Exclusive, a rare non-lounge pack version in even rarer Mativoire Beige, I believe it’s the only one in the UK. Serviced by ...
Thanked 1 time
Posted by Hattershaun on 01 October 2019

Water inlet manifold
Just restored cruiserphil's Tutorial - Click Here - on how to change the lower inlet tank 1336 Y2 for anyone else who has to do the job (everyone will eventually....)
Thanked 1 time
Posted by C6Dave on 27 September 2019

Fragile Under Bonnet Plastics on a C6
OK bracket at 'A' is now secured.




Had some aluminium strip so made a piece for the top and bottom, bonded the 'sandwich' with fibre glass resin on the bench when I had the pieces aligned and put a pop ...
Thanked 1 time
Posted by C6Dave on 26 September 2019

C6 2.7 HDI intake manifold cleaning
Hello Corne,

If your car is a 2.7 the filter bleed is very easy. I used to go through a more complicated routine until I got sense. There is a return to tank from the filter. When you have everything c...
Thanked 1 time
Posted by cruiserphil on 24 September 2019

Go to page       >>