C6owners :: Forums :: C6 Support :: The Garage |
<< Previous thread | Next thread >>
|
RHS front wheel arch liner removal |
Please Register to enjoy additional Member Benefits |
Author | Post | ||
Davet49 |
|
||
Joined: Oct 14 2018
Member No: #3695
Location: Winchester |
I need to replace my windscreen washer pump and I believe the best way to access it is to remove the front wheel arch liner. I can't find anything that describes how to do it. Is it easy? |
||
|
|||
MGmike |
|
||
Joined: May 21 2017
Member No: #3151
Location: South Queensferry |
Yes, one plastic rivet at the top of the arch, one on the inner wing and then about six Torx 30 screws around the edge of the bumper, two in the front of teh wheel arch and four along the bottom of the bumper. | ||
|
|
||
Davet49 |
|
||
Joined: Oct 14 2018
Member No: #3695
Location: Winchester |
Thank you. Are the plastic rivets reuseable or will I need to buy new ones? | ||
|
|
||
MGmike |
|
||
Joined: May 21 2017
Member No: #3151
Location: South Queensferry |
Reusable if you're careful. The top one is a pull out centre, the inner wing one is a push centre. If one breaks it'll be the top one but you should be okay. | ||
|
|
||
Davet49 |
|
||
Joined: Oct 14 2018
Member No: #3695
Location: Winchester |
Thanks. I'll wait for the new pump to arrive before I tackle this and even then, it will probably have to wait until next week. | ||
|
|
||
User Colour Key: Head Administrator, Administrator, C6 owner, Technical Expert, C6 Premier Discount Club |